Snowmobile Studs & Nuts

The "Super-Lite" backer is designed for the rider who is looking for lightweight stud support and vibrant colors. These backers are made from new ...

The "Super-Lite" backer is designed for the rider who is looking for lightweight stud support and vibrant colors. These backers are made from new e...

The "Super-Lite" backer is designed for the rider who is looking for lightweight stud support and vibrant colors. These backers are made from new ...

This Power Point Carbide Push-Through Stud is designed for the Ski-Doo XP and select Arctic Cat snowmobiles with single Ply Tracks. This stud will...

Reduces time required to stud track Available for 7mm and 1/4?-20 t-nuts Fits 3/8? square drives and drills

Pre-holed rubber straps and fixtures that secure rear flap to chassis Fits most models, with the exception of Polaris Rush chassis

Lightweight, steel construction for ultimate thread tolerance Use with t-nut style competition studs Tighten with torque wrench or hand ratchet: 9...

High-grade, lightweight aluminum support plates for single-ply studs Require indexing so edges run parallel with track’s edge – a great re-torque ...

High-grade, lightweight aluminum support plates for two-ply studs Require indexing so edges run parallel with track’s edge – a great re-torque ind...

High-grade, lightweight aluminum support plates for two-ply studs Install two studs per plate: reduce weight, increase scratch lines Must be paire...

High-grade, lightweight aluminum support plates for two-ply studs Require indexing so edges run parallel with track’s edge – a great re-torque ind...

A nut is affixed to this Round Digger support plate to ease installation and save time.

The superior t-nut style stud for grass drags and loose surface racing, as it grabs 30% more surface area than the standard Chisel Tooth stud. T...

When choosing your length, Woody's recommends snowmobile studs protrude 1/4" to 3/8" over the track lug.

A 60° carbide pin is surrounded by four flat sides, a patented design, to increase surface area and paddle snow. With performance in mind, this stu...

Wear Bar available Ace Dooly Executive Extender Trail III Hardweld Maverick Slim Jim 2.0 Standard Trail Blazer IV